kit - for any size window sash to 1.5 x 0.75 m - is inexpensive
The kit consists of:
Profile frame - 3 pcs.
Transverse profile (impost) - 1 pc.
Corner connector - 4 pcs.
Crossmember - 2 pcs.
Brackets for external mounting - 4 pcs.
Knife for seaming cord - 1 pc.
Net - 1 pc.
Handle - 2 pcs.
Rubber cord - 1 pc.
Production of mosquito net:
Measurement window
1) Measure the light of the opening window frame height and width.
2) The length of the profile for your mosquito net should be considered by the formula:
Width minus 3 cm length minus 3 cm.
Ie if the height and width of the light aperture of 136 cm and 62 cm, respectively, the size of 2 long profiles will be 133 cm. and 2 short 59 cm.
Cutting profile:
1) Cut the frame profile size obtained by the above formula.
2) Cut the transverse profile (impost) to the size of the opening width of the light minus 2 cm.
Assembling the frame
Fix the main profile with the supplied plastic parts to puzzles to fix the mosquito net were on one side inside the frame.
In the corner there is a special slot on 2 sides. Comes in tight profile, have to tamp lightly with a hammer.
Insert the transverse profile (impost) 2 fastening.
Connect with impost frame profiles and align the center of the frame cross member.
Installing the mosquito net in the frame
Lay the mesh on the assembled structure from the groove in the frame.
With the help of seaming knife - tuck the cord into the groove profile.
Rolled-up cloth should not sag and form wrinkles.
Surplus mosquito net and cut the cord office knife.
Mounting handles
Slightly lift cord and insert the handle into the groove of the main profile, charge cord.
Installing Framework mosquito net with metal brackets
To install you will need a measuring tape, screwdriver or drill with the bat for tightening screws.
Mark the outer side of the window frame to mount the included brackets and tighten them with the screws. Brackets with long slots should be installed on top of the frame, and short down.
After installing the brackets set mosquito net in the window. Hook the mosquito net to the frame through the upper bracket first, and then the lower anchorages.
In winter, the mosquito net must be removed.
